Tactile Surface Indicators

PolyPad Tactile Surface Indicators 600 x 900mm


The Retro-fitting Tactile surface indicator. Ph. 0356 342287 quick contact form

PolyPadTM Tactile indicators can be cut to any size or any requirement using a sharp blade. Our unique registered design and large pad sizes are purpose engineered, to omit excessive installation joins.

The size and configuration of the dated style 300mm x 300mm tactile, almost certainly lead to moisture ingress, through excessive failure points, ie.(joins) which are now associated with similar, inferior tactile surface indicator products.

For Friendly Advice Call: 0356 342287

TredRight Retro-fit poly Tactile Indicators, meet the Australian Standard AS/NZS1428 part 4 and are guaranteed to conform to all of the dimensional requirements in order to provide safe and effective tactile cues for the vision impaired.

R11 Slip Resistance, means that our tactile ground surface indicators are in accordance with the Australian Standards AS/NZ 4586:2004 Slip Resistant of pedestrian Surfaces.
TredRight tactile Products Exceed the slip resistance guidelines HB 197.1999 for external ramps, walk ways, pedestrian crossings and all requirements of the Australian Building Code of Australia.

 

  • Low cost solution, for meeting regulation guidelines
  • Ten Year Product and Installation Warranty.
  • Bold Colour fastness suitable for internal and external use.
  • Rapid Installation with minimal pedestrian disturbance.
  • Retro-fitting tactile has never been easier especially over an uneven substrate!

Poly Pad® Engineered for installation on: Cement - Exposed aggregate - Bitumen - Slate - Reconstitute Ceramics - Linoleum Timber - Ferrous and Non Ferrous metals - Retro pads can also be layered flush finish into Carpet & Vinyl.

Poly PadTM Sizes

  • 600mm Wide X 900mm Long X 2mm Thick. With Raised Discs.
  • 300mm Wide X 900mm Long X 2mm Thick. With Raised Discs.

Standard Colours:

Dark Grey, Light Grey, Yellow, Black, Ivory

Ocean Blue, Sky Blue, Sun Set Orange, Terracotta


How to order or specify PolyPad® Retro-fit

Quote or simply copy & paste the reference below, omit the the colours which are not applicable to your preference. 

TredRight PolyPad®. Colour Either Black, Yellow, Ivory, Grey, Light Grey, Sky Blue, Ocean Blue, Terracotta, Sun set orange. Attachment to substrate is permanent with TredRight quick dry epoxy adhesive. PolyPad® is to be installed according to TredRight specifications, or by a TredRight accredited installer. Website: www.tredright.com.au  Email: mail@tredright.com.au  Ph 0356 342 287

 

You are invited to use Our Quick Enquiry Contact form located in the contact page of this website, (Typical response time 2hrs)